Maxxus LifePlate 4.0 User Manual page 8

Operating Instructions
Before you can use the remote control, you must remove the protective foil from the battery. Open the battery compartment cover,
remove the protective foil from the battery and then replace the battery compartment cover again.
Before you use the remote control for the first time, you must connect it to the vibration plate. To do this, switch on the vibration plate at
the main switch on the side of the device and then press the power button on the remote control.
CAUTION:
If you switch on the vibration plate at the main switch and then press the power button on the vibration plate cockpit it will no longer be
possible to connect with the remote control. , the connection with the remote control is no longer possible.
If this is the case, switch the vibration plate off and on again at the main switch and then proceed as described above.
Correct sequence to connect the remote control with the vibration plate:
Step 1:
Switch the vibration plate on at the main switch
Main Switch
Incorrect sequence to connect the remote control with the vibration plate:
Step 1:
Switch the vibration plate on at the main
switch
Main Switch
Step 2:
Hold the remote control over the vibration plate and press the
power button
Step 2:
Press the power button on the cockpit.
If you have used the wrong sequence to connect the remote control to the vibration
plate, just switch off the plate at the main switch. After approximately 10 seconds, switch
it on again and try to connect the remote control with the vibration plate again.
8
CR 2032
Remove the protective foil
.
Step 3:
Hold the remote control over the vibration
plate and press the power button .