Edit Chase; Edit Scenes/3. 25 Scenes Record Mode - ProLights RUBYFCX User Manual

RUBYFCX
16
If, for example, a Slave unit is set to Slave 1 Receive, the Master unit will send the automatic program Chase Part
1 to the Slave unit; if set to art 2 Receive, the Slave unit will receive Chase Part 2 from the Master unit.
To set the unit as Slave, proceed as follows:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll through the menu, select the Stand Alone icon, then press the ENTER
button to enter the next Play menu.
• Press the ENTER button and select Slave Receive with the UP/DOWN button, then confirm the choice
with the ENTER button.
• Press the UP/DOWN button to select the different operating modes Slave 1 Receive/Slave 2 Receive/Slave 3
Receive, then press the ENTER button to confirm the choice.
• Press the LEFT button repeatedly to exit the menu and to save the changes made.
On the master unit, select the desired program as indicated in paragraph 3.5.
Use the RUBYFCX DMX connectors and an XLR cable to form a chain of units. In certain conditions and
lengths it is advisable to carry out a termination as shown on page 19.
3.21 OPERATIONS IN AUTOMATIC MODE
The unit can carry out its show program autonomously. Before sending an automatic program in execu-
tion it is necessary to set the unit as Master/Alone:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll through the menu, select the Stand Alone icon, and then press the
button ENTER to enter the next Play menu.
• Press the ENTER button and select Sequence with the UP/DOWN button, then confirm the selection with
the ENTER button.
• Press the UP/DOWN button to select the operating mode:
- Master, if the unit is connected in series to other units and it performs the function of Master;
- Alone, if the unit is not connected to other units.
• Press the ENTER button to confirm the selection.
• Press the LEFT button repeatedly to exit the menu and to save the changes made.
The unit will go into automatic mode by running the automatic program.
3.22 SELECT CHASE
The Select Chase function allows you to choose the automatic program to be executed.
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll through the menu, select the Stand Alone icon, and then press the
button ENTER to access the next menu.
• Press the UP/DOWN button to select Select Chase and press the ENTER button to enter the menu following.
• Press the UP/DOWN button to select Chase Part 1/Chase Part 2/Chase Part 3 and press the ENTER button to
confirm your choice.
• Press the UP/DOWN button to select the preferred Chase1 - Chase8, then press the ENTER button.
• Press the LEFT button repeatedly to exit the menu and to save the changes made.
3.23 EDIT CHASES
The Edit Chases function allows you to create preprogrammed automatic shows.
The Chase Part1/2/3 automatic programs are divided into Chase1-Chase8 each. Each Chase can be composed of
1-64 steps that can be configured through the following procedure:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll through the menu, select the Stand Alone icon, and then press the
button ENTER to access the next menu.
• Press the UP/DOWN button to select Edit Chases and press the ENTER button to enter the menu following.
• Press the UP/DOWN button to select Edit Chase 1 - Edit Chase 8, then press the ENTER button for confirm.