Installing The Heat Sink - Fujitsu CELSIUS M770 Operating Manual

Installing the heat sink

Never operate the device without the heat sink fitted!
Before initial startup, install the heat sink again in the same way as it was
installed in the device before removal. The air flow direction is indicated by
an arrow on the heat sink. Install the heat sink so that the arrow for the
air flow direction points towards the rear panel.
► Insert the heat sink into the casing (1). In doing so, correctly align the screw holes
on the heat sink with the screw holes on the mainboard (2).
► Tighten the screws (a) with a torque of 1 Nm.
► Install the ventilation duct (see
► Close the casing (see
Fujitsu
2
"Install ventilation duct", Page
"Close the casing", Page
2
48).
44).
System expansions
2
2
2
a
95