Installing And Removing Heat Sinks; Removing The Heat Sink; Installing The Heat Sink - Fujitsu CELSIUS W510 Operating Manual

System expansions
► Press on the retaining clip until it you feel it engage (2).
► Close the casing (see
If you have installed or removed a PCI board, please check the relevant PCI
slot settings in the BIOS Setup. If necessary, change the settings. Further
information is provided in the PCI board documentation.

Installing and removing heat sinks

Removing the heat sink

The shape and position of the heat sink are device-dependent.
► Open the casing (see
► Disconnect the cable of the fan (FAN1) from the mainboard.
► Undo the screws on the heat sink.
► Lift the heat sink out of the casing.

You can now replace the processor.

Installing the heat sink

► Open the casing (see
► Reinstall the heat sink so that the air flow is fed towards the back of the
casing (see arrow on the heat sink).
► Tighten the screws.
► Connect the fan cables to the mainboard.
Never attach or detach fans during operation. This can cause problems
controlling the mainboard fan.
60
"Closing the casing", Page
"Opening the casing", Page
"Opening the casing", Page
36).
35).
35).
Fujitsu Technology Solutions