Siemens SIMATIC ET 200eco Manual page 58

Commissioning and diagnostics
ET 200eco startup
Switch on 1L+ and, if required,
2L+ for ET 200eco
The LEDs "ON","24 VDC"
and "BF" are lit*
ET 200eco sets the outputs to
"0" state and applies the set
PROFIBUS address
ET 200eco receives configur–
ation data from the DP master
configuration data com-
patible to the physical
LED "BF" is switched off; the in-
puts/outputs are enabled;
ET 200eco and the DP master
are ready to exchange data
* The "24 VDC" LED is not available for I/O module 8 DI or I/O module 16 DI
Figure 4-1
4-4
Are the
No
configuration?
yes
ET 200eco startup
SF is lit red
BF flashes red
Switch off 1L+ for ET 200eco
Adapt the configuration data to
your system or vice versa
ET 200eco Distributed I/O Station
A5E00158716-02