Connecting The Ecofast Connector - Siemens SIMATIC ET 200eco Manual

How to connect the ECOFAST connector
1. Push down the interlocking mechanism for the ECOFAST connector.
2. Insert the ECOFAST connectors (for 1L+, 2L+ and PROFIBUS DP) into the
sockets of the terminal block. Note the mechanical encoding of the connectors
for incoming signals and loop–through.
3. Close the interlock of the ECOFAST connector.
1
3
Figure 3-7
Caution
It is not permitted to disconnect the ECOFAST connector during ET 200eco
runtime! Always switch off the load voltage supply (2L+) before you disconnect the
ECOFAST plug.
ET 200eco Distributed I/O Station
A5E00158716-02
2

Connecting the ECOFAST connector

Wiring
3-21