Nortel Optical Multiservice Edge 6130 Planning Manual page 76

6-16 OAM&P description
•
•
The WAN application in the local craft access terminal allows the user to
perform the following:
•
•
•
•
SDH payload instance numbering
In the local craft access terminal, SDH payload instances are displayed using
J, K, L, and M format where:
•
•
•
•
For example, a format of J = 3, K = 2, L = 6, M = 2 identifies:
•
•
•
•
For detailed procedures and associated rules, refer to Provisioning and
Protection Switching Procedures, 323-1855-310.
Optical Multiservice Edge 6130
Note 1: The systems blocks any cross-connects that are illegal. For
example, if a low-order VC12 cross-connect is provisioned, the system
blocks cross-connects of the corresponding VC3/VC4.
operate or release user-initiated switch commands on SNCP connections.
delete a nodal connection (supports multiple deletes)
provision VC associations within a WAN from any 10/100BT Ethernet or
Gigabit Ethernet interface port to any available timeslot of an STM-1/4
interface on the same OME6130 network element.
operate or release user-initiated switch commands on SNCP VC
connections.
delete a VC association within a WAN (supports multiple deletes)
click on hyperlink to Cross-connect application to filter, display or delete
nodal connections.
J is the AU-4 payload number (1 to 4 for STM-4 line rate and fixed at 1 for
STM-1 line rate)
K is the TUG-3 payload number (1 to 3)
L is the TUG-2 payload number (1 to 7)
M is the TU-12 payload number (1 to 3) or TU-11 payload number (1 to 4)
AU-4 number 3
TUG-3 number 2
TUG-2 number 6
TU-12/TU-11 payload number 2
NT6Q92MA Rel 1.0 Iss 1 Standard September 2006