Stm Pm Parameters; Pdh / Dsn Performance Monitoring - Nortel Optical Multiservice Edge 6130 Planning Manual

STM PM parameters

STM PM parameters are accumulated for the STM-1/4 interfaces on the circuit
packs.
Table 6-11
SDH PM parameters summary
Facility
Regenerator
Section (RS)
Multiplex section
(MS)
Path (HO AU)
Tributary Unit (LO
TU)
Tranceiver
(physical)

PDH / DSn performance monitoring

Path performance monitoring for E1/DS1 port is limited and dependant on the
PDH/DSn path monitoring mode assigned to the unframed/framed PDH/DSn
ports as described in the
Path performance parameters are monitored when the path monitoring mode
for the selected framed port is set to Alarm and Performance Monitoring. Path
performance parameters are also counted for unframed E1/DS1 ports only
based on AIS condition.
Line performance monitoring is fully supported on all PDH/DSn ports. Path
performance monitoring is fully supported on all E3/DS3 ports.
Table 6-11 provides a summary of the supported STM PM parameters.
PM parameter
SDH: ES, SES, UAS, SEP, EB, BBE, ESR, SESR, BBER, SEPI
SDH: ES, SES, UAS, SEP, EB, BBE, ESR, SESR, BBER, SEPI, ES-FE,
SES-FE, BBE-FE, UAS-FE, SEP-FE
SDH: ES, SES, UAS, SEP, EB, BBE, PPJE, NPJE, ESR, SESR, BBER, SEPI,
ES-FE, SES-FE, BBE-FE, UAS-FE, SEP-FE
SDH: ES, SES, UAS, SEP, EB, BBE, ESR, SESR, BBER, SEPI, ES-FE,
SES-FE, BBE-FE, UAS-FE, SEP-FE
Received Power, Transmit Power, Laser Bias, Laser Voltage, Laser
Temperature
Planning Guide NT6Q92MA Rel 1.0 Iss 1 Standard September 2006
PDH / DSn alarm monitoring on page
OAM&P description 6-33
6-31.