Ethernet Connection; Usb Connection - Ametek Teseo CBA Series Operation Manual

Configure the selected Port as per the below settings.
Bits per second
Data Bits
Parity
Stop Bits
Flow Control
To place the amplifier in remote operation type in a valid command such as
"STATUS". The amplifier will then go into remote operation and the status will be
displayed on the computer.
8.4

Ethernet Connection

With the amplifier powered down connect via an Ethernet cable to the network. Power
the amp up and wait (5/10 seconds) for the amplifier to acquire an IP address
dynamically. The acquired IP address will then be displayed on the touch screen in the
top right-hand corner.
Note: The port number is 10001 and a DCHP server is required to address the
amplifier.
To assign a static IP to the amplifier, you must first establish a remote connection. Once
connected, type the command Settings to enter the User Settings Mode. Once in this
mode, you can enter the command Edit to begin configuring the static IP settings. The
Edit Settings Values are as follows:
STATIC IP
STATIC IP Value
SAVE SETTINGS
8.5

USB Connection

Note: A USB cable with an FTDI chip set is required for this form of communication.
FTDI drivers are required to assign the USB interface a virtual com port. If these are
not installed on the PC in use they can be downloaded from,
http://www.ftdichip.com/FTDrivers.htm
Ensure the drivers are loaded and installed on the PC in use before connecting via
USB. With the amplifier powered down connect to the USB interface. Power the
amplifier up and the interface will be assigned a virtual com port. The COM Port
number can be discovered as per the RS232 method (8.3). Again, a terminal
application will be required to communicate with the amplifier using the same setting
as per the RS232 method (8.3)
CBA Manual: H012161 Rev: 3
RS-232 / USB Configuration Settings
RS-232
9600
8
None
1
None
21
USB
9600
8
None
1
None
Y/N
XXX.XXX.X.XX
Y/N