Connections; General; Rf Input, N Type Connector - Ametek Teseo CBA Series Operation Manual

7

CONNECTIONS

7.1

General

The CBA series has an RF In, RF Out and a built in dual directional coupler with N-
Type forward and reflected connections. These are available in two configurations,
either all on the front or all on the rear of the amplifier. The CBA series are equipped
with either a N-Type or a 7/16
datasheet) but the same standard shall still apply; all RF connections are either on the
rear or on the front of the amplifier. The interlock, remote connections, AC connector,
and interconnecting cables are always located on the rear panel.
Summary
Front Panel
Function
Amplifier Mains
Breaker
Local/Remote Switch
RF On/Off Switch
Fault/Reset Switch
Colour Touch Screen
Display Status
Gain Control,
Function
RF Input & Output
FWD/RFL Sample Ports
7.2

RF input, N Type connector

CAUTION!
The maximum input level detailed in the specification sheet and on the
amplifier front panel must not be exceeded. Do not expose the centre pin of
the RF-input connector to static discharge. The signal source must be at DC
zero.
Refer to the specification sheet for details of RF input levels. The nominal input
impedance is 50 ohms.
Hints and tips: Don't forget that modulated or complex signals may have a peak
power that may not be indicated on the signal source. Always ensure that the peak
level of the input signal is within the limits specified in the applicable datasheet.
CBA Manual: H012161 Rev: 3
th
RF output connecter (model dependent, see applicable
Comment
3 Phase Main
Breaker
Amplifier Tray &
Touch Screen PSU Tray DC Power
interconnect.
Touch Screen AC Power Connector
Touch Screen Interlock, BNC
Touch Screen IEEE 488, Connector
Touch Screen Ethernet
RS232
USB
Ground Post
Front or Rear Panel RF Connectors
Configuration Dependent
Configuration Dependent
16
Rear Panel
Function Comment
Model Dependent
Model Dependent
Comment