JUKI DDL-9000C-S Series Engineer's Manual page 144

List of input functions
Abbreviation
0 NOP No function
1 HS Needle up/down correction stitching
2 BHS Reverse-feed correction stitching
Function for cancelling reverse-feed
3 EBT
stitching (at end) once
4 TSW Thread trimmer function
5 FL Presser lifter function
6 OHS 1-stitch correction stitching
Function for cancelling reverse-feed
7 SEBT
stitching (at start) (at end)
Function for prohibiting depress on
8 LINH
the front part of pedal
Thread trimmer output prohibition
9 TINH
function
10 LSSW Low-speed command input
11 HSSW High-speed command input
12 USW Needle lifter function
13 BT Reverse-feed stitching switch input
14 SOFT Soft-start switch input
15 OSSW One-shot speed command switch input
R e v e r s e - f e e d o n e - s h o t s p e e d
16 BKOS
command switch input
17 SFSW Safety switch input
Automatic reverse-feed stitching
18 AUBT
cancellation/addition switch
19 CUNT Sewing counter input
20 OTSW One-touch change-over switch
5. Setting of an input function
Select the function allocated to an input signal from an input function list.
Select a function item B by pressing the
Display a selection of HIGH or LOW by pressing the
output to switch between LOW and HIGH.
After the setting is completed, fix the set contents by pressing the
(Caution) When you turn off the sewing machine without pressing the
not reflected.
Function item
❶, and enter the function item by pressing the
– 128 –
Remark
(Standard setting)
Every time the switch is pressed, normal feed
stitching by half stitch is performed.
Reverse feed stitching is performed at low speed
while the switch is held pressing.
By depressing the back part of the pedal after
pressing the switch, operation of reverse feed
stitching is canceled once.
This function is actuated as the thread trimming
switch.
This function is actuated as the foot lifter switch.
Every time the switch is pressed, one stitch
stitching operation is executed.
By operating the optional switch, ineffective/
effective can be alternately changed over.
Rotation by pedal is prohibited.
Output of thread trimming is prohibited.
This function works as low speed switch for
standing sewing machine.
This function works as high speed switch for
standing sewing machine.
UP stop motion is performed when switch is
pressed during DOWN stop.
Reverse feed stitching is output as long as the
switch is held pressed.
The speed of stitch is limited to the predetermined
soft-start speed as long as the switch is held
pressed.
This function works as one-shot speed command
as long as the switch is pressed.
Reverse feed stitching is performed in accordance
with the one-shot speed command as long as the
switch is held pressed.
Rotation is prohibited.
Every time the switch is pressed, reverse feed
stitching at sewing start or reverse feed stitching
at sewing end is cancelled or added.
Every time the switch is pressed, the sewing
counter value is increased.
This function changes the settings of a pattern
stitch mode every time the SW (switch) is pressed.
❶, and move to active level selection F of
❻.
❻, the set contents are
❷.