JUKI DDL-9000C-S Series Engineer's Manual page 123

No.
U052 Correction of turning-OFF of reverse feed stitching (at start)
U053 Correction of turning-OFF of reverse feed stitching (at end)
U055 Presser foot lift after thread trimming
The initial value differs with the machine head.
0: No lift / 1: Lift
U056 Reverse-rotation needle-up after thread trimming
The initial value differs with the machine head.
0: Reverse-rotation needle-up is not performed /
1: Reverse-rotation needle-up is performed
U057 Function for lowering the feed dog during thread trimming
The presser foot height is fixed at 0 (zero) during thread trimming.
0: OFF / 1: ON
U059 Selection of revere feed stitching (at start) operation
0: Manual / 1: Automatic
U060 Stop after reverse feed stitching (at start)
The stop function stops the sewing machine temporarily
regardless of the operating status of the pedal.
0: OFF / 1: ON
U064 Sewing speed at the start of reverse feed stitching (at end)
U068 Presser foot lifting operation changeover
The presser foot lifting operation when depressing the back part
of pedal is changed over.
0: 2-step operation / 1: Manual operation depending on the pedal
stroke when the back part of pedal is depressed
U069
Presser-foot 1st step lifting height
Maximum height of presser foot at the 1st step of its lifting
operation when the back part of pedal is depressed.
Item Setting range Unit
SMS
−50 to 50 Degree 0
−50 to 50 Degree 0
0 to 1 - 1
0 to 1 - 0
0 to 1 - 1
0 to 1 - 1
0 to 1 - 0
150 to 1000 sti/min 500
0 to 1 - 0
0.1 to 8.5 mm 5
Initial value
SSH FMS FSH SMS CE SSH CS FMS CE FSH CE
0 0 0 0
0 0 0 0
1 1 1 1
0 0 0 0
1 1 1 1
1 1 1 1
0 0 0 0
500 500 500 500
0 0 0 0
5 5 5 5
0 0 0
0 0 0
1 1 1
0 0 0
1 1 1
1 1 1
0 0 0
500 500 500
0 0 0
5 5 5