JUKI DDL-9000C-S Series Engineer's Manual page 107

⑧ No.09 Output check
1. Select an output to check.
No. Output name
Thread trimming
01
solenoid
02 Thread presser
* When the origin retrieval is not performed, a thread trimming solenoid does not operate.
2. Complete an output check.
When you press the
* When a needle bar is not at the upper position, the thread trimming solenoid does not operate.
⑨ No.10 Compensation of neutral point of the pedal sensor
⑩ Complete a compensation of neutral point of the pedal sensor.
When you press the
(Caution) At this time, the pedal sensor does not work properly if the pedal is depressed. Warning
sound "blips" and the correct compensation value is not displayed.
❶
Display
Out put OFF
❻, the current screen returns to the selection screen of a check program.
❶
❻, the current screen returns to the selection screen of a check program.
– 91 –
When you press the
can select an output to check.
The outputs that can be selected are as
follows:
❻
Status
Out put ON
1．As shown in the figure on the left, when
it is properly corrected, it will be dis-
played "OK" and the correction value.
（Correction value of the left figure "10"
is a reference value）
2. When you press the
the correction value and return to the
selection screen of a check program.
❻
❶, you
❺ to confirm