JUKI DDL-9000C-S Series Engineer's Manual page 135

Error
Description of error
code
E205 ISS buffer capacity
runout warning
E220 Warning against
shortage of grease
E221 Grease-shortage
error
E302 Head-tilt detection
error
(When the safety
switch operates)
E303 Meniscus sensor
error
E402 Deletion disabled
error
E407 Wrong password
E408 Shortage of number
of password
characters
E411 Polygonal stitching
pattern registration
disabled error
E412 Custom pitch
unregistered error
E413 Condensation
custom unregistered
error
E499 Simplified program
fault
E704 Data failure (system-
version mismatch)
E731 Motor hole sensor
fault
E733 Reverse rotation of
motor
E750 Sewing machine
stops
Cause
• Buffer for storing ISS data will soon be
filled to its capacity.
If the buffer is used continuously, the
stored data will be automatically erased
on FIFO basis.
• When the predetermined number of
stitches is reached.
• In the case the sewing machine
cannot continue sewing since the
predetermined number of stitches is
reached.
• In the case the Tilt detection switch
is turned ON when the power to the
sewing machine remains ON.
• In the case the meniscus sensor signal
cannot be detected.
• In the case of attempting to delete the
pattern which is used in a cycle pattern.
• In the case of attempting to delete the
custom pitch or condensation custom
which is used in a pattern.
• In the case the password entered is
wrong.
• In the case the number of password
characters entered is not enough.
• In the case of attempting to create
eleven or more polygonal stitching
patterns.
• In the case the custom pitch number is
faulty.
• In the case the condensation custom
number is faulty.
• In the case the system version does not
match the machine head setting.
• In the case the motor signal is not input
properly.
• When the motor runs at a speed of
500 sti/min. or more, the motor runs in
the reverse direction of the indicated
direction of rotation.
• In the case the optional-input safety
switch is pressed.
– 119 –
Item to be checked
• Output the ISS data.
• Add grease to the specified points of
sewing machine and reset the error.
• Add grease to the specified points of
sewing machine and reset the error.
• Check whether the machine head
is tilted before turning OFF the
power switch (The sewing machine
operation is prohibited for the sake of
safety.)
• Check for a break in the motor
encoder connector.
• Re-write the system version to the
applicable one.
• Check whether the motor signal
connector has loosened or slipped
off.
• Check whether the motor signal cord
has broken by being caught under
the machine head.
• Check whether the insertion direction
of the motor encoder connector is
correct.
• Check whether the main shaft motor
encoder wire connection is correct.
• Check whether the main shaft motor
wire connection for power is correct.