Connecting Software To The Internal Gps - CHC LT500T User Manual

18. Set both drop down boxes:
to 'My ISP'. Then click 'OK' to return to the
'Advanced' tab. Then click 'OK' to return to
the main menu.
19. Verify that your LT500T is connected by
turning off Wi-Fi:

Connecting Software to the Internal GPS

The internal GPS receiver has two serial ports which connect to the LT500T's internal COM1 and
COM6 ports. Both ports are always active. Commands can be sent to either port, and NMEA
strings can be streamed from either/both ports.
By default, the baud rate for each of the ports (COM1 and COM6) is set to 38,400. If you connect
SurvCE to the internal receiver using the 'CHC' 'LT500T' driver, SurvCE will set the baud rate to
9600 baud. We strongly recommend that you don't use the SurvCE internal driver and instead use
the NMEA driver.
You can control which NMEA sentences are sent to each port using LTSet.
Then browse to a web site using Internet
Explorer:
20. After the connection is made, the correct
web page should be displayed:
Success! You are connected to the internet
via the cellular modem.
16
iGage LT500T User Manual