CHC i80 GNSS Quick Tour With Survce
Internal uhf base mode
Hide thumbs
Also See for i80 GNSS:
- User manual (103 pages) ,
- Quick start manual (28 pages) ,
- Maintenance manual (13 pages)
Advertisement
Advertisement
Table of Contents
Related Manuals for CHC i80 GNSS
Summary of Contents for CHC i80 GNSS
- Page 1 CHC® i80 GNSS Receiver Quick Tour with SurvCE (Internal UHF Base Mode)
- Page 2 Satel protocols. Enter a job name and select a projection 2.2 Base setting in SurvCE Power on the receiver Long press the i80 power button until the i80 GNSS Receiver Quick Tour with SurvCE (Internal UHF Base)
- Page 3 Mobile and then click the icon →select Click [Current] [Manufacturer] in CHC→select [Model] in i80 After click the icon the follow interface will show and click [Find Device] to search BT device around i80 GNSS Receiver Quick Tour with SurvCE (Internal UHF Base)
- Page 4 Note: if you want to measured the slant height of i80,please refer to the follow 10. Click on the icon to build up the figure. Bluetooth connection i80 GNSS Receiver Quick Tour with SurvCE (Internal UHF Base)
- Page 5 13. Set the parameters of Internal UHF set and there is two ways to set the including protocol, power, channel, sensitivity coordinates A:From known position and over the air baud then click the icon i80 GNSS Receiver Quick Tour with SurvCE (Internal UHF Base)
- Page 6 [Read From GPS] 16. After start the base, the base file can be saved or not Set the points number need to be collected then click the icon i80 GNSS Receiver Quick Tour with SurvCE (Internal UHF Base)
- Page 7 17. Please check the green LED of i80 whether is flashing. If so, it means the base configuration is successfully. i80 GNSS Receiver Quick Tour with SurvCE (Internal UHF Base)
Need help?
Do you have a question about the i80 GNSS and is the answer not in the manual?
Questions and answers