Ethernet Interface Configuration - Advantech PCM-4822 User Manual

Ethernet Interface Configuration

The PCM-4822's on-board Ethernet interface supports all major
network operating systems. I/O adress and interrupts are easily
configured via the RSET8019.EXE program included on the utility
disk.
The RSET8019.EXE program provides two ways to configure the
Ethernet interface. Configuration can be done automatically when
you choose PNP (plug and play). When you choose jumperless
configuration, the following IRQ and I/O address settings are
available.
PCM-4822 Ethernet Settings
Jumperless
Configuration
Default Settings: IRQ=5; Address=300H
Note:
To execute the configuration, to view the current configuration, or
to run diagnostics do the following:
1. Power the PCM-4822 on. Ensure that the RSET8019.EXE file is
located in the working directory.
2. At the prompt type RSET8019.exe and press <Enter>. The
Ethernet configuration program will then be displayed.
IRQ option
2, 5, 10
11, 15
1. You can select an IRQ from the Options shown
above, but be certain that your selection does not
conflict with other I/O devices.
2. When Boot ROM is installed, the RSET8019.EXE
program does not support PNP mode configuration.
I/O address range
200-300EFH
Chapter 3 Software Configuration 27