Chapter 7 Pci Bus Ethernet Interface; Introduction; Installation Of Ethernet Driver; Installation For Ms-Dos And Windows 3.1 - Advantech PCM-9577 User Manual

Chapter 7 PCI Bus Ethernet Interface

7.1 Introduction

The PCM-9577 is equipped with a high performance 32-bit Ethernet
chipset which is fully compliant with 802.3u 100BASE-T \Fast Ethernet
CSMA/CD standards (PCM-9577F) and compliant IEEE 802.3z/ab
1000BAS-T Gigabit Ethernet(PCM-9577FG). It is supported by major
network operating systems. It is also both 100Base-T and 10Base-T com-
patible.
The Ethernet port provides a standard RJ-45 jack via an optional wiring
kit. The network boot feature can be utilized by incorporating the boot
ROM image files for the appropriate network operating system. The boot
ROM BIOS files are combined with system BIOS, which can be enabled/
disabled in the BIOS setup.

7.2 Installation of Ethernet driver

Before installing the Ethernet driver, note the procedures below. You
must know which operating system you are using in your PCM-9577
Series, and then refer to the corresponding installation flow chart. Then
just follow the steps described in the flow chart. You will quickly and
successfully complete the installation, even if you are not familiar with
instructions for MS-DOS or Windows.
Note:

7.2.1 Installation for MS-DOS and Windows 3.1

If you want to set up your Ethernet connection under the MS-DOS or
Windows 3.1 environment, you should first check your server system
model. For example, MS-NT, IBM-LAN server, and so on.
Then choose the correct driver to install in your biscuit PC.
The installation procedures for various servers can be found on the sup-
plied CD-ROM, the correct path being:
PCM-9577 User's Manual
The windows illustrations in this chapter are
examples only. Follow the steps and pay atten-
tion to the instructions which appear on your
screen.
D:\Biscuit\9577\LAN\82559er\wfw311
96