Mark And Drill Door - Cal-Royal CRCODE-204 Instruction And Programming Manual

Mark and Drill Door

1. Attach TEMPLATE onto door and verify backset
and latchbolt center before marking and drilling
the holes on the door.
To Change Handing To Change Handing
OUTSIDE LOCK
(Lever shipped Right Handed)
1. Insert key and turn 90° clockwise.
2. Insert lever catch on the bottom
of the lever.
3. Pull lever off.
4. Fit lever to the desired opposite
left hand of the door.
5. Turn key 90° clockwise and push
lever until it clicks.
6. Make sure the outside lever is
secure and working smoothly.
7. Pull out key.
2. Drill holes on the door according
make sure this is
set horizontally
4
3
to the model you have.
6
5
6605 Flotilla St., Commerce, CA 90040
Tel (323) 888-6601 Fax (323) 888-6699
www.cal-royal.com