Step 5
Return to the freezer with a small amount of cleaning
solution. Brush clean the rear shell bearing(s) at the
back of the freezing cylinder(s) with the black bristle
brush.
Figure 36
Step 6
Remove the rear drip pan(s) and take to the sink for
cleaning.
Models 750, 751, 754, 774, 791, 794
Note: If the drip pan is filled with an excessive amount
of mix, refer to the Troubleshooting Guide.
Step 7
Thoroughly brush clean all disassembled parts in the
cleaning solution making sure all lubricant and mix film
is removed. Take particular care to brush clean the
draw valve core(s) in the freezer door. Place all the
cleaned parts on a clean, dry surface to air dry
overnight.
Step 8
Wipe clean all exterior surfaces of the freezer.
31
Operating Procedures