Release G.03.13 12/13/02 - HP ProCurve 4100GL Series Operating

Software Fixes

Release G.03.13 12/13/02

Port Configuration (PR_3028) — Changing a port setting from one Auto mode to another
may not be reflected in Auto-negotiation's advertised capability without a switch reset, or
module hot-swap.
Port Monitoring (PR_3596) — Port monitoring does not work correctly after a TFTP
transfer of the configuration from the switch to the server and then back to the switch.
Stack Management (PR_3493) — Master switch was not properly making security checks
when passing information along to a member switch.
TFTP (PR_3518) — Menu and browser displays of switch configuration are not accurate
after a TFTP transfer of the switch config file to the switch. Only occurs when a port is
configured for network monitoring.
Web-Browser Interface (PR_1483) — User could input an invalid MAC address, i.e.
multicast or broadcast address, in the security policy field.
Web-Browser Interface (PR_3113) — Incorrect font size used in VLAN configuration
screen.
Web-Browser Interface (PR_3519) — Web display of port utility window did not display
port H24.
Release G.03.13 12/13/02
Inter-module Communication Problems (PR_3856) — When the switch's MAC address
learning function detects the same MAC address on two different modules within a small
interval of time (this could happen if two end nodes have the same MAC address or if there
is a loop in the network), the address tables on the modules may get out of sync. This can
cause module-to-module communication problems for devices connected to the modules
whose address tables have become out of sync.
XMODEM (PR_2999) — If the CLI "copy xmodem flash" command is used to download
the OS, the switch incorrectly displays one of the two following messages after the validate
and write process completes: 1) "User timeout, must hit ENTER before starting XMODEM
Transfer"; or 2) "Transfer terminated due to timeout"
Release G.03.12
Never released.
Update to the Manufacturing-only test routine.
21