Fixes; Version Ka.15.03.3005; Version Ka.15.03.3006 - HP J9575A Manual

Fixes

Software fixes are listed in chronological order, from oldest to newest software version. Unless otherwise noted, each new
software version includes all the software fixes added in previous versions.
KA.15.03.3004 was the initial software version for the HP 3800 switches.

Version KA.15.03.3005

Status: Released and fully supported, but not posted on the Web.
The following problems were resolved in software version KA.15.03.3005.
■ CLI (PR_0000072869, CR_0000077695) - The switch does not allow the use of a dash or an underscore ("-" or "_")
in an unauth-redirect URL.
■ Crash (PR_0000072341, CR_0000077244) - With a client connected to a port configured for MAC-based
authentication and unauth-redirect, if that client fails authentication the switch might reboot unexpectedly with a
message similar to the following.
Software exception at hwBp.c:211 -- in 'fault_handler', task ID = 0xaa3d1c0
Crash (PR_0000103369, CR_0000103369) - A switch configured with the command web-management ssl might
■
reboot unexpectedly with a message similar to the following.
Software exception at http_init.c:543 -- in 'tHttpd', task ID = 0xa984d80
■ Port Crash (PR_0000103236, CR_0000103236) - Although rare, a group of ports on the 48-port switch might
reboot unexpectedly. The ports will not recover until the switch is rebooted. The affected ports are 1-24 and 49-50.
The event log will display a message similar to the following.
chassis: ST2-CMDR: Ports 1/1-24,49-50 crash detected
■ Stacking (PR_0000072434, CR_0000077325) - With a stack connected as a ring, when one of the stack members
is rebooting the stack allows the user to reboot a different member, which can fragment the stack.

Version KA.15.03.3006

Status: Released and fully supported, and posted on the Web.
The following problems were resolved in software version KA.15.03.3006.
■ CLI (PR_0000070114, CR_0000075294) - The switch gives an error message when the user adds a port to an
existing voice VLAN. Also, a VLAN already configured with a tagged port cannot later be configured as a voice VLAN.
■ CLI (PR_0000071092, CR_0000076119) - Multiple voice VLANs are no longer allowed. With this fix, multiple voice
VLANs are allowed again.
■ Crash (PR_0000072472, CR_0000077356) - In some situations the switch might reboot unexpectedly with a
message similar to the following.
Crash msg: Invalid Instr
HW Addr=0x00000000 IP=0x0 Task='mSess2' Task ID=0xa91a700
sp:0x6446788 lr:0x12c4824
msr: 0x02029200 xer: 0x20000000 cr: 0x48000400
15