Release G.05.06 - HP ProCurve 4100GL Series Operating

Software Fixes

Release G.05.06.

Menu (PR_5346) — The one-line help text below the password entry field, displays the
message "Enter up to 16 characters (case sensitive), or just press <Enter> to quit". It should
read "sensitive".
Port Configuration (PR_5444) — When interchanging 10/100-TX modules J4862A and
J4862B, the port configuration of the module originally installed in the switch is lost.
Port Counters (PR_5171) — The "Total RX Error" counter is incorrect when the port has
heavy 10HDx traffic.
Port Counters (PR_5204) — The Runt Rx counter in the detail port counter screen, does
not increment when there are fragments.
Port Counters (PR_5400) — The 64-bit counter for the highest numbered port on a given
module, does not update properly.
RADIUS (PR_4886) — Pressing the tab key gives error message similar to "BAD CHAR­
ACTER IN ttyio_line: 0x9n" when entering a username for the radius prompt.
SNMP (PR_5349) — The switch does not send SNMP packets larger than 484 bytes.
SNTP/TIMEP (PR_5018) — SNTP still runs when timep is enabled.
System Information (PR_5169) — Up Time displayed is not correct.
TFTP (PR_5034) — Trying to TFTP a config onto the switch causes the switch to not
complete its reload process. The switch hangs and does not come up.
Web-Browser Interface (PR_4495) — Administrator password can be used in combina­
tion with the operator username.
Web-Browser Interface (PR_4904) — When a transceiver is removed from the switch, its
configuration is not cleared on the Status->port status screen of the web UI. The transceiver
type will still show until a new transceiver is inserted.
Web-Browser Interface (PR_4996) — When using a ProCurve Switch 4108 as a
commander switch in the stack, a ProCurve Switch 2424M is not shown in the device view
of the stack closeup in the web UI. The message "Device view, HP2424M, not supported by
firmware of commander" is present instead of the device view.
Web-Browser Interface (PR_5055) — Missing firmware/ROM information in Web UI.
Web-Browser Interface (PR_5158) — When clicking on the Web UI System Info "Apply
Changes" button, a character appears under the "VLAN Configuration" tab.
Release G.05.06.
Never released.
13