Char-Grill-Vdsc536T-4Q, Vdsc548T-6Q; Vdsc536T-4Gq - Viking VDSC548T Series Service Manual

Service Diagnostics and Procedures
To avoid risk of electrical shock, personal injury, or death, disconnect gas supply and electrical power to unit
before servicing. Discharge capacitor through a resistor before attempting to service. Wires removed during
disassembly must be replaced on proper terminals to insure correct earth ground and polarization. After
servicing, reconnect electrical power and gas supply. Before placing appliance into operation, always check
for gas leaks with soapy water solution. DO NOT USE AN OPEN FLAME TO CHECK FOR GAS LEAKS.
Char-Grill–VDSC536T-4Q, VDSC548T-6Q,
VDSC548T-4GQ
The 18,000 BTU char-grill is equipped with a single
piece, heavy-duty porcelainized cast-iron grill grate
for easy movement of grilling items. Beneath the
grill grate is a slotted porcelainized flavor-generator
plate which is designed to catch drippings and
circulate a smoke flavor back into the food. Beneath
the flavor-generator plate is a two piece drip
pan which catches any drippings that might pass
beyond the flavor-generator plate.
To remove the char-grill assembly:
1. Remove the char-grill grate, flavor-generator
plate, and the drain pan.
© 2011 Viking Preferred Service
WARNING
2. Remove securing screws and burner.
Grill
3. Disconnect igniter wire. Remove securing
Flavor
Generator Plates
Drain Pan
Burner
4. Repair or replace char-grill.
5. Reverse procedure to reinstall.
Note: The drip pan is a two-piece drip pan.
Note: Located beneath the burner is the drip tray.
Under normal grilling circumstances, very little if
any grease will accumulate in the drip tray.
Burner
Screw
screws and igniter.
Burner
Screw
Screw
Igniter Wire
93