User Settings-30" Oven - Viking VDSC548T Series Service Manual

Diagnostics
User Settings–30" Oven
SET HR MIN
88:88 MIN/SEC
AM
PM
STOP TIMER NO PROBE
COOK TIME ON DELAY
To adjust settings:
1. Press "CLEAR/SETTINGS" and hold three seconds to activate.
2. Toggle "SELECTOR KNOB" right or left to desired setting.
3. When desired setting is flashing, press "SELECTOR KNOB" to change value.
User Setting
(Parameter) Function
DEGREES
Select Temperature format. Default is ˚F.
HOURS
Select Time format. Default is 12 hr.
SABBATH
Default is off. Refer to EOC4 Product Specification. In general,
any operation that can change state based on the door opening
(lights, fans, etc.) is disabled. If Sabbath Mode is enabled, display
SABBATH.
BRIGHTNESS
Select the brightness from 1-5 with 5=brightest setting. Default
is 5.
SHOWROOM
Disables heating elements, cooling fan and convection fan motor.
Oven lights and all display functions operate normally.
EXIT
Final step in User Settings. From this step, the user can either exit
the User Settings (press on the
the diagnostic mode (see page 45).
Note: To enter offset you can be any of the above User Settings.
© 2011 Viking Preferred Service
CLOCK/
PROBE
TIMER
COOK
TIME
STOP
TIME
OVEN
FUNC
00000000
OVEN
TEMP
888°8
OFF
CLEAR/ CLEAN/
SETTINGS
SETTINGS
"SELECTOR KNOB"
) or enter
Selection
˚F / ˚C
12 / 24
NO / SABBATH
1 - 5
NO / YES
43