Iris Module Removal; Char-Grill Burner And Igniter Removal (Vdsc536-4Q, Vdsc548-6Q, & Vdsc548-4Gq); Griddle Temperature Sensor (Rtd) Removal (Vdsc536-4G, Vdsc548-6G, & Vdsc548-4Gq); Griddle Burner Removal (Vdsc536-4G, Vdsc548-6G, & Vdsc548-4Gq) - Viking VDSC530 Service Manual

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.

IRIS Module Removal

Condition Requirements:
Control Panel Assembly Removed
1. Disconnect connectors from module.
2. Pull to remove module from burner valve.
3. Reverse procedure for installation.
Char-Grill Burner and Igniter Removal
(VDSC536-4Q, VDSC548-6Q, & VDSC548-4GQ)
Condition Requirements:
Grill, Plate, and Drip Pans Removed
1. Disconnect wire from igniter.
2. Remove two screws and igniter from burner.
3. Remove two screws and burner from range.
4. Reverse procedure for installation.
©2009 Viking Preferred Service
Griddle Temperature Sensor (RTD) Removal
(VDSC536-4G, VDSC548-6G, & VDSC548-4GQ)
Condition Requirements:
Griddle Plate and Drip Pan Removed
1. Remove two screws that attach the sensor to the
range.
2. Pull the sensor until the sensor connector is visible.
3. Disconnect sensor connector.
4. Reverse procedure for installation.
Griddle Burner Removal
(VDSC536-4G, VDSC548-6G, & VDSC548-4GQ)
Condition Requirements:
Griddle Plate and Drip Pan Removed
1. Remove four screws, griddle burner bracket, and
griddle burner from range.
2. Remove screw and griddle burner bracket from
griddle burner.
3. Reverse procedure for installation.
Griddle Burner Igniter Removal
(VDSC536-4G, VDSC548-6G, & VDSC548-4GQ)
Condition Requirements:
Griddle Plate and Drip Pan Removed
1. Remove two screws and igniter from range.
2. Disconnect wire from igniter.
3. Reverse procedure for installation.
Disassembly
39