Door Removal - Viking VDSC548T Series Service Manual

Service Diagnostics and Procedures–Disassembly Service Diagnostics and Procedures
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit using power
switch before servicing. Wires removed during disassembly must be replaced on proper terminals to insure
correct earth ground and polarization. After servicing, reconnect power using power switch.

Door Removal

1. Open door completely. Place pins, supplied
with unit, in pinhole. For personal safety,
ONLY use pins supplied with the unit.
2. Remove hinge trim screws. Take off hinge trim.
Identify right and left hinge for future
re-installation.
© 2011 Viking Preferred Service
WARNING
3. Close until pins stop door. Lift door up
and out.
4. Reverse procedure to reinstall.
Note: VDSC530T shown.
107