Cleaning And Care; General Information On Cleaning And Disinfection; Cleaning And Disinfection Of The Device Surface And Upholstery; Recommended Surface Disinfectants - Atmos Chair 21 P Operating Instructions Manual

5.0 Cleaning and care

5.1 General information on cleaning and disinfection

Prior to cleaning
Medical chairs such as the ATMOS
) The described measures relating to cleaning and
disinfection resp. sterilisation do not replace the relevant
instructions which must be adhered to prior to operation!
• For disinfection, you may use all surface and upholstery
disinfectants listed in chapter 5.3 and 5.4 "Recommended
disinfectants".

5.2 Cleaning and disinfection of the device surface and upholstery

• The surfaces of the ATMOS
and 5.4. Nevertheless after a longer period of use discolouration could occur.
• Substances such as blood must be removed immediately to prevent stains.
• The device itself can be wiped off with a moist (not wet) cloth.
Do not use aggressive or abrasive cleansing agents. For the upholstery standard dry foam may be used.
!
Treatment with a commonly used care product for artificial leather is recommended once a week in order to keep the upholstery
soft and smooth.

5.3 Recommended surface disinfectants

• The surfaces of the ATMOS
QAV (quaternary ammonium compounds)

5.4 Recommended disinfectants for the upholstery

Disinfectant
ATMOS Green & Clean SK
®
(Application solution)
10
Chair 21 P must be failsafe at all times.
®
Chair 21 P are resistant against all the recommended surface disinfectants stated in chapter 5.3
®
Chair 21 P can be cleaned / wiped with disinfectants containing the following active ingredients:
®
Ingredients
Di alkyl dimethyl ammonium chloride
Alkyl dimethyl ethyl benzyl ammonium
chloride
Alkyl dimethyl benzyl ammonium chloride
) Always observe the concentration specifications and
instructions by the respective manufacturer!
• Do not use
- Disinfectants which contain organic or inorganic acids
or bases as they could cause corrosion damage.
- Disinfectants containing chloramides, phenol
derivatives or anionic tensides, as these may cause
stress cracks in the plastic material used.
(in 100 g)
< 1 g
< 1 g
< 1 g
Manufacturer
Metasys, Rum (Austria)