4.0
Operation
Fig 7.
Multifunctional lever ATMOS Chair 21 P
Fig 8.
Lever for adjusting the backrest
4.1
Adjusting the seat height
The swivel joint must be arrested (multifunctional
lever in uppermost position = swivel locking) in all
cases, prior to access respectively exit of the patient.
Move the multifunctional lever (
manner to adjust the chair upwards.
Arrest the chair in the desired position (multifunctional
lever in highest position = height locking).
By pressing the multifunction lever completely down, the
chair can be adjusted to its lowest position.
4.2
Rotating the upper part
The upper part of the chair with the patient can be
completely rotated by moving the multifunction lever from
its highest position (rotation arresting) to the fi rst snap-in
position or even lower till the brake is completely released.
Then rotate the upper part of the chair with the patient and
move the multifunction lever again in highest position
(rotation arresting) when the desired position is achieved.
4.3
Adjusting the backrest
The backrest can be adjusted to the desired position by
pressing the lever (
, fi g. 8) backwards.
Release the lever which will then return to its initial position.
The backrest remains in the adjusted position.
When pressing the lever again backwards the installed
gas compression damper will induce the backrest to
return to upright position.
, fi g. 7) in a pumping
9