Quadra-Fire 4300 Series Installation Manual page 23

6. Remove knock out from bottom of firebox by using a
hammer (Figure 20.2 on page 20).
7. Install ash door assembly by sliding the rod at an angle
into the slot on the left side (Figure 20.3 on page 20).
8. Slide the ash door over the 8 screws protruding from
the bottom of the appliance. Secure with nuts and
washers using 7/16 socket wrench (Figure 20.3 on
page 20).
9. Install ARS latch by sliding latch assembly over 2
threaded studs protruding from the bottom on the left
hand side of the appliance. Secure by using two nuts
use 7/16 socket wrench (Figure 21.1 on page 21).
10. Add knob to handle rod (Figure 21.2 on page 21).
11. Use 2 bolts and two flange nuts to secure ARS channel
using 3/8 open end wrench and 7/16 socket wrench
(Figure 20.3 on page 20).
Installing Queen Anne Leg ARS Kit
1. Follow Beginning installing the ARS system instructions
provided on page 21.
2. Install ARS Spacer on left hand side with one bolt using
Phillips head screwdriver (Figure 21.4 on page 21).
3. Install leg brackets and ash drawer using four screws
using Phillips head screwdriver.
Start bottom two bolts through ash drawer, leg brackets
and into the bottom of the appliance (Figure 23.1).
Align top holes and repeat; secure all four bolts.
4. Install legs onto leg brackets making sure the legs
are up against the bracket and secure with bolts and
washers using a 3/8 open end wrench (Figure 23.2).
5. Install leveling bolts into 2 legs; these leveling legs
should be in opposite corners (Figure 23.2).
6. Carefully stand appliance up and place in desired
location.
7. Use leveling bolts on legs to stabilize and level
appliance (Figure 23.3).
Finishing the ARS Installation
1. Replace 2 front bricks that were removed (Figure
23.4).
2. Install the ash drawer to ASH Removal receiver.
3. Install ARS access cover inside of ARS Channel that is
located inside the firebox (Figure 23.4).
CAUTION!
CHECK BAFFLE BOARDS & CERAMIC BLANKET!
• Verify that the baffle boards and ceramic blanket are
in their proper locations.
• It is important that the baffle boards and ceramic
blanket are correctly installed for proper burn safety.
August 13, 2018
4300 Wood Appliance Series ACC
Lay appliance flat on
its back on protective
padding or pallet
Figure 23.1
Leg Brackets
Figure 23.2
Figure 23.4
7037-172G
Align top holes
and repeat; secure
Ash Removal Box
Insert 2 bottom screws loosely
Leveling Legs at
Opposite Corners
Figure 23.3
ARS Access
Cover
Reinstall 2 front
bricks back into
firebox
Ash Drawer
23