To Release The Steam; To Replace The Operating Valve; Using For The First Time P; Before Cooking P - T-Fal P31052 User Manual

. .
• Press down on the central section and turn the valve to line
up the position with the marker (L)
• Remove the valve.

To replace the operating valve

• Fit the operating valve, lining up the
(L).
• Press down on the central section and then turn to the
required position
To make blackening
of aluminium
disappear from
already used
products : repeat
"first use"
instructions with
baking soda.
Cooking
Before cooking
• Before each use, remove the operating valve (A) (see
section "Using the operating valve")
these by holding them up to the light, making sure
the steam release outlet is not clogged
If necessary, clean with a tooth pick
- Fig 7
.
• Fill the pot with 1/2 water. Add 4 tablespoons of
baking soda.
• Put the operating valve (A) in place on the steam
release outlet (B)
• Position the symbol
- Fig 7
marker (L)
• Close the pressure cooker.
• Place the pressure cooker on a heat source set to
maximum power.
• When steam begins to exit the valve
down the heat source and set a timer to 20 min.
• After 20 min., turn off your heat source.

To release the steam

• Position the symbol
marker (L).
• Rinse your pressure cooker.
To replace the operating valve
• Fit the operating valve, lining up the
marker (L).
• Press down on the central section and then turn to
the required position.
- Fig 5
. .
with the marker
Using for the first time
- Fig. 5
.
1
on the valve (A) opposite the
.
on the valve (A) opposite the
- Fig. 5
. Check
- Fig. 11
.
- Fig. 11bis
.
EN
Fig 12
, turn
. .
with the
5