LifeSpan LS Series Manual page 15

MAINTENANCE
WARNING
Fold up:
1. Raise the frame.
The electronics are continuously running self checks. If it finds an irregularity, the console will display an "Error" code and stop the
normal operation of the treadmill for safety purposes.
Speed sensor error :
1. Please check if there is anything stuck inside.
2. Please check if the speed sensor is loose or defective.
3. Please contact your after-service center.
Motor connection error :
1. Please check cable connection to motor are not loose or damaged.
2. Please contact your after-service center.
PCB panel control board and MCB motor control board connection error :
1. Please check all cables connected to the console PCB and motor controller MCB are not loose or damaged.
2. Please contact your after-service center.
Controller protection error :
Please contact your after-service center.
Motor protection error :
Please contact your after-service center
Motor controller (MCB) protection error :
Please contact your after-service center
Incline error (only MI150) :
Please contact your after-service center
HRC program error (only MI150) :
1. Please make sure that the hands are placed on the hand pulse grips or the chest strap is worn.
(Chest strap is an optional function.)
2. Please check if the wiring of the hand pulses are not loose or damaged.
3. Please contact your after-service center.
PLEASE REMOVE THE SAFETY KEY AND TURN OFF THE POWER SWITCH.
THEN TURN THE POWER SWITCH BACK ONTO SEE IF THE ERROR CODE HAS CLEARED
13
IF THERE IS STILL AN ERROR CODE PLEASE CONTACT YOUR AFTER-SERVICE CENTER.
Folding/Unfolding
LS-7T:
Before folding, please put the incline value to zero (0) level.
On right side
of handlebar
1. Pull out the knob for locking.
Treadmill Leveling
To stabilize the treadmill on the floor, you can adjust the two screws located under the front
of the base frame.
1. Lift the machine on one side and then turn the screw under the front
of the base frame.
2. Turn the screws clockwise to make it screw up.
3. Turn the screw counterclockwise to make it screw down.
Trouble shooting with error codes
Release to unfold:
On right side
of handlebar
1. Push the deck forward.
2. Pull out knob for releasing.
1. Lower the deck with hand support.