Precautions For Installation - Panasonic AK-HRP1000G Operating Instructions Manual

Precautions for Installation

In addition to the safety precautions given in "Read this first!", also observe the following instructions.
Be sure to ask your dealer to perform the installation and connection work for the unit.
Cable connections
Be sure to use dedicated ROP cables (Hirakawa Hewtech Corp. 20379-FG-SV-10 cables or equivalent).
If the unit will not be used for an extended period of time, disconnect the ROP cables to save electricity.
Concerning PoE power supply
The unit complies with the IEEE802.3af standard. Use a compatible Ethernet hub and PoE injector to use a PoE power supply.
For details on Ethernet hubs and PoE injectors for which operations have been verified, consult your dealer.
Grounding
Ground the system via the <SIGNAL GND> terminal on the unit.
A.
<SIGNAL GND> terminal
Handle carefully
Dropping the unit or subjecting it to a strong impact or vibration may cause a failure or accident.
Do not allow any foreign objects to enter inside the unit.
Allowing water, metal items, food or drink, or other foreign objects to enter inside the unit may cause a fire or electric shock.
Installation location
This unit is designed for indoor use only.
Use the unit on a stable and horizontal surface that is sufficiently capable of supporting its weight.
When the unit will be recessed into a panel or table, make sure that enough space is provided for ventilation and cables.
Do not install the unit in a location where it and the cables can be easily damaged.
Do not install the unit in a cold place where the temperature drops below 0°C (32°F) or in a hot place where the temperature rises
above 40°C (104°F).
Avoid installing the unit where it will be exposed to direct sunlight or near an outlet from which hot air is blown out.
Installing the unit in a location with a lot of humidity, dust, or vibration may result in a failure.
A
- 14 -
Introduction