Panasonic AK-HRP1000G Operating Instructions Manual page 136

Connection settings
B
C
D
E
F
B CAMERA NO column
C CAMERA TYPE column
D CAMERA MODEL column
E MAC ADDRESS column
F IP ADDRESS column
G CAMERA PORT NO column
I J
Displays the camera numbers.
Click and select the connection type.
The connection types are identical to those of [CONNECT SETTING] in the unit's ROP menu.
"Serial", "NetWork"
Select when connecting with the AK-HC5000 series, AK-UC3000 series, or AK-UC4000
series.
"Serial": Serial connection, "NetWork": IP connection
"Serial(AK)", "NetWork(AK)"
Select these when connecting the AK-HC3500A series or AK-HC3800 series.
"Serial(AK)": Serial connection, "NetWork(AK)": IP connection
"Serial(AW)", "NetWork(AW)"
Select these when connecting the AK-UB300 series.
"Serial(AW)": Serial connection, "NetWork(AW)": IP connection
"NoAsign"
Not specified (default setting).
"Serial", "Serial(AK)", and "Serial(AW)" cannot be specified for multiple cameras.
Displays the connected devices acquired with the [NETWORK SEARCH] button (I).
The CCUs connected via a serial connection are not displayed.
Displays the MAC addresses of cameras linked with camera numbers [CAMERA NO] (B) on the
unit.
MAC addresses of devices corresponding to camera numbers acquired by the [NETWORK
SEARCH] button (I) are displayed.
Set the IP addresses of the CCUs to be connected. After input, click the [SET] button (K) to
reflect the changes.
Set the port numbers of CCUs to be connected.
After input, click the [SET] button (K) to reflect the changes.
Possible setting range
1 to 65535
However, the following values cannot be set even though they are within this range.
20, 21, 23, 25, 42, 53, 67, 68, 69, 110, 123, 161, 162, 995, 10669, 10670
Setting for normal operation
For normal operation, configure the setting as follows. However, if the setting has been
changed on the camera side, the setting must be matched to that setting.
CCU IP: 49152
- 136 -
K L M
Software
G
H