Adjustment And Settings; Auto Setup; Starting Auto Setup - Panasonic AK-HRP1000G Operating Instructions Manual

Adjustment and settings

Auto Setup

Starting auto setup

Before starting auto setup
Choose [SYSTEM CAM] > [ASU MODE] in the ROP menu to select "FULL" or "EASY" mode.
"ASU MODE" (see page 104)
FULL Standard setup based on an outdoor shooting chart
EASY Easy setup based on an outdoor shooting chart
Align the position of the gray scale wedge with the angle of view in the vertical direction of the viewfinder. Be sure to correctly select the pos-
ition from which you shoot the chart since some positions may not enable a satisfactory auto setup.
Recommended gray scale
Starting auto setup
A. [AUTO SET UP] button
Operating procedure
1. Press the [AUTO SET UP] button (A).
The [AUTO SET UP] button flashes while the auto setup start preparation mode is established, and a square marker appears in
the center of the camera viewfinder. Align the white at the center of the gray scale with this square marker. (To cancel setup, press
and hold this button.)
2. Press the [AUTO SET UP] button (A) again.
The [AUTO SET UP] button lights as auto setup starts. (Holding down the [AUTO SET UP] button during the auto setup operation
will abort auto setup.)
The [AUTO SET UP] button goes off when auto setup ends successfully.
If the [AUTO SET UP] button flashes at approximately 1-second intervals, auto setup has ended without being com-
pleted. During the auto setup operation, the picture monitor (PM) displays characters to indicate operation status.
If auto setup is not completed, check the message on the picture monitor (PM) on the CCU.
A
- 36 -
Adjustment and settings