PARTS LIST: • Main wing L and R : 1 pc/each • Landing gear steel wire : 1 pc • Fuselage : 1 pc • Wood support plate of landing gear 1 set • Stiffened of Fuselage : 2 pcs •...
Page 4
1. Join two wing halves together with foam-safe glue. 2. Insert two pieces of 990mm x 2mm carbon rods to the wing's top and bottom surface respectively. 3. Glue and secure the carbon rods to the wing's top and bottom with foam-safe glue. 4.
Page 5
7. Ensure the fuselage is arrow-straight. Wait till the glue is dry. 8. Insert the wing into the fuselage wing slot. (See picture) 9. Before apply glue onto the wing and fuselage joints, ensure the wing is centred and perpendicular to the fuselage.
Page 6
12. Lay the elevator on a flat surface. Insert two supplied 330mm x 4mm wood strips into the slots on the elevator and stabilizer respectively. Once statisfied with the fit. Apply glue to the wood strips and let it dry. 13.
Page 7
17. Use a Xacto knife to make another 4 slots which correspond to the ones on the rudder. Then insert those paper hinges to the rudder post and apply glue to secure it. 18. Install the supplied plastic horn on the elevator as shown. 19.
Page 8
22. Install and glue the motor mount to the fuselage as shown. 23. Insert both wheels on the steel wire and use hot shrink tube to hold the wheels in place. 24. Install the landing gear to the mounting plate as shown. 25.