Advertisement
1
1. Join two wing halves together with foam-safe glue.
2. Insert two pieces of 990mm x 2mm carbon rods to the wing's top and bottom surface respectively.
3. Glue and secure the carbon rods to the wing's top and bottom with foam-safe glue.
4
4. Insert 2 pieces of carbon rods with the length of 780mm into the slot of the stiffener as shown.
Note: Pay attention to the left/right direction.
5. Lay the fuselage on a flat surface and glue the stiffener on to the fuselage as shown. Please do
both sides. Note: Ensure both stiffeners are well aligned properly to the wing slot and the stabilizer
slot as well. Wait till the glue is dry.
6. You may glue the carbon rod with foam-safe glue at this time.
2
5
3
3
6
Advertisement
