Advertisement
22
22. Install and glue the motor mount to the fuselage as shown.
23. Insert both wheels on the steel wire and use hot shrink tube to hold the wheels in place.
24. Install the landing gear to the mounting plate as shown.
25
25. Install your desired brushless motor to the motor mount with tapping screws.
26. Use a set of velcro tape to attach your desired radio receiver to the fuselage. Note: Be prepared to
move the receiver back and forth to achieve the right C of G. Use a set of velcro tape to attach your
desired battery pack on the front part of the fuselage.
Note: Be prepared to move the receiver back and forth to achieve the right C of G.
27. The centre of gravity should be 120-130mm from the front edge of aircraft wing.
We suggest that you add 1- 2 degrees of right-thrust, which can be achieved by adding
one washer or two behind the top and right side of the motor (between the motor and the
motor mount). When set properly, the trim for the elevator and the rudder should be
neutral. Fine-tune the down-thrust and right-thrust until this trim is achieved. When doing
flight test, we suggest you should keep the flight balance according to the centre of gravity
we recommend. When doing 3D flight test, you can move slightly the centre of gravity
backward.
General flight: Aileron: 20 degrees, Elevator: 20 degrees, Rudder: 20 degrees.
3D flight: Aileron : 45-55 degrees, Elevator: 45-60 degrees, Rudder: 45-60 degrees.
Seek Assistance: If you are a beginner in the R/C field, we suggest you turn to an
experienced pilot for help with the first few flights.
23
26
7
24
27
Advertisement
