Advertisement
12
12. Lay the elevator on a flat surface. Insert two supplied 330mm x 4mm wood strips into the slots on
the elevator and stabilizer respectively. Once statisfied with the fit. Apply glue to the wood strips
and let it dry.
13. Install the stabilizer onto the fuselage as shown
14
14. Please ensure the stabilizer is squared and parallel to the main wing first.
Once satisfied with the fit, apply glue to the joints between the wing and the fuselage. Set it
aside and wait till the glue to dry.
15. Install a supplied plastic horn onto the rudder. The rudder horn should be positioned 92mm
from the rudder base. The holes on the control horn should be aligned to the hinge line to
ensure the rudder deflection is symmetrical
16 Use a Xacto knife to make 4 evenly spaced slots on the rudder as shown. Insert 4 paper
hinges halfway into the slots and glue it. Wait till the glue to dry.
12
15
5
13
16
Advertisement
