Ethernet Interface (Rj-45); Delivery Status Of The Cmmo-St; Dhcp Or Fixed Ip Address - Festo CMMO-ST Manual

5 Commissioning
5.2

Ethernet interface (RJ-45)

5.2.1

Delivery status of the CMMO-ST

Note
The CMMO-ST is equipped during production with a active DHCP server (Dynamic Host
Configuration Protocol).
• Before adding the CMMO-ST to an existing network, please observe the instructions
in section 5.2.5 "Initial start-up", as these will enable you to prevent network mal-
functions.
Computers with an active DHCP client accept all DHCP servers. If two DHCP servers are activated in a
network by mistake, the functionality of the network may be impaired.
CMMO-ST network settings
Parameters
IP
DHCP server
Port
Subnet mask
Gateway
Tab. 5.1 Network settings: delivery status
5.2.2

DHCP or fixed IP address

Behaviour of the DHCP server
The DHCP server of the CMMO-ST is intended to establish a direct connection between the CMMO-ST
and an individual computer. It is not intended to supply larger networks with IP addresses.
It assigns IP addresses in a range of 192.168.178.110 ... 192.168.178.209 and the subnet mask
255.255.255.0. A gateway is not assigned.
Additional configuration options
DHCP client
The CMMO-ST can also be configured as a DHCP client. It then obtains its IP address from a DHCP
server in your network.
Specifying a fixed IP address
Alternatively you can also assign a fixed IP address to the CMMO-ST.
These settings can be adjusted, if required, in FCT (
Festo – GDCP-CMMO-ST-EA-SY-EN – 1301a – English
Value
192.168.178.1
Active
Web browser: 80
FCT: 7508
CVE (= Control via Ethernet): 49700
255.255.255.0
0.0.0.0 (none)
section 6.4.3).
41