Table of Contents
Advertisement
6 Device Configuration and Commissioning
All newly delivered devices are factory-configured so as to support all
available interfaces.
Setting enCore device parameters, i.e. configuring device functions and
adapting the device to the actual measuring point, is done on site using the
enSuite software.
enSuite system requirements and installation
System requirements and details about how to install enSuite are
available in a separate installation guide. The currently valid
version of the file is always located on the enSuite installation CD.
Alternatively you can download the PDF from the Elster Instromet
website from the section Software downloads:
www.elster-instromet.com/en/software-downloads
A gas specialist must be consulted for this procedure. The presence of a
metrology expert is also required when the device is being used within the
scope of legal metrology.
The online help function in enSuite software contains instruc-
tions for operating enSuite as well as a detailed description of its
parameters.
6.1 Device Configuration
This section gives brief instructions on how to create a complete confi-
guration for enCore devices and how to transfer the configuration into the
device on-site via USB. For details refer to volume "Configuration of
Device Software" of the FC1 manual.
enCore FC1
Operating Instructions
Page 79 of 97
Advertisement
Table of Contents
