Table of Contents
Advertisement
6
Device Configuration and Commissioning
In very rare cases, it may happen that the device shows a
prohibitive sign in the home display
after parameterization and
restart, e.g.:
Fig. 6-1: Emergency mode
The prohibitive sign indicates that the device has started in
emergency mode due to a system error that has been detected
during re-start. In this case only basic functionalities for error
handling are active; all the other functions are disabled.
Typically, this error is caused by an erroneous parameterization
configuration and can be solved by transferring a correct para-
meterization to the device.
Please contact us if you require further assistance for diagnosing
the error.
6.2 Commissioning the Measurement System
The presence of a metrology expert is required for final commis-
sioning of the device when it is used within the scope of legal
metrology. In this case, the conditions of the applicable authori-
zation must be observed as well.
enCore FC1
Operating Instructions
Page 81 of 97
Advertisement
Table of Contents
