Emerson Rosemount 2051 Series Quick Start Manual page 17

February 2019
• LOI – see
• Class 2 master – see
5.2 Configuration tools
5.2.1 Local operator interface (LOI)
When ordered, the LOI can be used for commissioning the device. To activate
the LOI, push either configuration button located under the top tag of the
transmitter. See
information. The security jumper prevents changes made using the LOI.
Note
Buttons must be fully engaged ≈ 0.5-in. (10 mm) of travel.
Table 5-1: LOI Button Operation
Button
(1) Characters blink when they can be changed.
Figure 5-1: LOI Menu
5.3 Class 2 Master
The Rosemount 2051 PROFIBUS DD and DTM files are available at
EmersonProcess.com/Rosemount
See Table 5-2
measurement. See Rosemount 2051
configuration instructions.
Table 5-2: Pressure Configuration via Class 2 Master
Steps
Set blocks to Out of Service
Quick Start Guide
Table 5-1 and Figure 5-1
Table 5-2
Table 5-1 and
Action Navigation
Scroll Moves down menu
categories
Enter Selects menu
category
1. ADDRESS
2. CALIBRATION
3. UNITS
4. DAMPING
5. DISPLAY
6. IDENTIFICATION #
7. EXIT
for steps to configure the transmitter for Pressure
for parameter configuration
Figure 5-1 for operation and menu
Character Entry
Changes character
(1)
value
Enters character and
advances
PRESSURE
FLOW
LEVEL
TEMPERATURE
or by contacting your local salesperson.
Reference Manual
Actions
Put Transducer Block into Out of Service mode
Quick Start Guide
Save?
Changes between
Save and Cancel
Saves
0-126
ZERO
LOWER SENSOR
UPPER SENSOR
RESET FACTORY
for Flow or Level
17