ABB ACS880-37LC Hardware Manual page 91

PE
6. If fire insulation is used, make an opening in the mineral wool sheet according to the
diameter of the cable.
7. Remove rubber grommets from the cable entries for the cables to be connected. Cut
adequate holes into the rubber grommets. Slide the grommets onto the cables. Slide
the cables into the cubicle through the conductive sleeves and attach the grommets to
the holes.
8. Attach the conductive sleeves to the cable shields with cable ties. Tie up the unused
conductive sleeves with cable ties.
Electrical installation 91
PE
11