Vega VEGABAR 86 Operating Instructions Manual page 35

Reset - Diagnosis
Menu item
Sensor status
Peak value
Simulation
Reset - Additional settings
Menu item
PIN
Date/Time
Copy instrument set-
tings
Special parameters
Scaling
Additional settings - Copy
instrument settings
VEGABAR 86 • Modbus and Levelmaster protocol
6 Set up the sensor with the display and adjustment module
Parameter
Pressure
Temperature
Parameter
Scaling size
Scaling format
The instrument settings are copied with this function. The following
functions are available:
•
Read from sensor: Read data from sensor and store into the
display and adjustment module
•
Write into sensor: Store data from the display and adjustment
module back into the sensor
The following data or settings for adjustment of the display and ad-
justment module are saved:
•
All data of the menu "Setup" and "Display"
•
In the menu "Additional adjustments" the items "Reset, Date/Time"
•
The user-programmable linearization curve
The copied data are permanently saved in an EEPROM memory in
the display and adjustment module and remain there even in case of
power failure. From there, they can be written into one or more sen-
sors or kept as backup for a possible electronics exchange.
Note:
Before the data are saved in the sensor, a safety check is carried out
to determine if the data match the sensor. In the process the sensor
type of the source data as well as the target sensor are displayed. If
the data do not match, a fault message is outputted or the function is
blocked. The data are saved only after release.
Default value
-
Actual measured value
Actual temperature values from measuring cell, elec-
tronics
Process pressure
Default value
0000
Actual date/Actual time
No reset
Volume in l
0 % corresponds to 0 l
100 % corresponds to 0 l
35