Vega VEGABAR 86 Operating Instructions Manual page 27

Setup - Measurement
loop name
Setup - Application
Setup - Units
VEGABAR 86 • Modbus and Levelmaster protocol
6 Set up the sensor with the display and adjustment module
Additional adjustments: PIN, date/time, reset, copy function
Info: Instrument name, hardware and software version, date of manu-
facture, sensor features
Note:
For optimum adjustment of the measuring point, the individual sub-
menu items in the main menu item "Setup" should be selected one
after the other and provided with the correct parameters. If possible,
go through the items in the given sequence.
The submenu points are described below.
In the menu item "Sensor TAG" you edit a twelve-digit measurement
loop designation.
You can enter an unambiguous designation for the sensor, e.g. the
measurement loop name or the tank or product designation. In digital
systems and in the documentation of larger plants, a singular desig-
nation must be entered for exact identification of individual measuring
points.
The available digits include:
•
Letters from A ... Z
•
Numbers from 0 ... 9
•
Special characters +, -, /, -
In this menu item you activate/deactivate the slave sensor for elec-
tronic differential pressure and select the application.
VEGABAR 86 can be used for process pressure and level measure-
ment. The setting in the delivery status is process pressure measure-
ment. The mode can be changed in this adjustment menu.
If you have connected no slave sensor, you confirm this with "Deac-
tivate".
Depending on the selected application, different subchapters in the
following adjustment steps are important. There you can find the
individual adjustment steps.
Enter the requested parameters via the appropriate keys, save your
settings with [OK] and jump to the next menu item with the [ESC] and
the [->] key.
In this menu item, the adjustment units of the instrument are deter-
mined. The selection determines the unit displayed in the menu items
"Min. adjustment (Zero)" and "Max. adjustment (Span)".
27