Vega VEGABAR 86 Operating Instructions Manual page 33

Submersible pressure transmitter with ceramic measuring cell

Hide thumbs Also See for VEGABAR 86:

Table of Contents

Diagnostics - Peak val-

ues, temperature

Diagnosis - Simulation

Additional settings - Date/

Time

Additional settings -

Reset

VEGABAR 86 • Modbus and Levelmaster protocol

6 Set up the sensor with the display and adjustment module

The respective min. and max. measured values of the measuring cell

and the electronics temperature are stored in the sensor. In menu

item "Peak value, temperature", both values are displayed.

In another window you can carry out a reset of the two peak values

separately.

In this menu item you can simulate measured values. This allows the

signal path to be tested, e.g. through downstream indicating instru-

ments or the input card of the control system.

Select the requested simulation variable and set the requested value.

To deactivate the simulation, you have to push the [ESC] key and

confirm the message "Deactivate simulation" with the [OK] key.

Caution:

During simulation, the simulated value is output as 4 ... 20 mA current

value and with instruments 4 ... 20 mA/HART in addition as digital

HART signal. The status message within the context of the asset

management function is "Maintenance".

Note:

Without manual deactivation, the sensor terminates the simulation

automatically after 60 minutes.

In this menu item, you adjust the internal clock of the sensor. There is

no adjustment for summer/winter (daylight saving) time.

After a reset, certain parameter adjustments made by the user are

reset.

Table of Contents