Advertisement
RX2A PRO Bind(S.BUS),transmitter(FLYSKY FS-i6)
BIND:Power on the receiver while pressing the key,green LED fast blink meaning already in bind mode,
user can release the key,then set your TX into bind mode.Green LED turn off and red LED solid mean bind finished,
exit TX from bind mode,receiver' sgreen LED solid mean working normally.
Firmware Update
BETAFLIGHT firmware allready flash before leave the factory,user just need connect PC to adjust the parameter
1.Open betaflight configuration
MATEKF411
3.5.3- MATEKF411 -15-11-2018 13:35(stable)
2.Click
updating finish into setting menu
3.Calibration"Calibrate Accelerometer"
4.Selected UART3,then open"Serial RX"switch and saved
,then click
,then click
-7-
,select FW version
to download FW to FC, click
after FW
Connect
Advertisement
