Table of Contents
Advertisement
5. Under the Engineering Units column, Deg C is selected by default. If you want to change
this setting, change the temperature units under the Acquisition Config - Acquisition
tab.
In this example, Deg C is used.
6. If you know the offset for your calibrated thermocouple and RTD, enter it under the EU
Offset column. For this example, leave 0 as the EU offset for the thermocouple and RTD
channels and 1000 as the EU offset for the voltage input channel.
7. Leave the test point values for each channel unchanged.
8. Click Close to close the Channel Configuration dialog box.
Verifying the Operation of Your Instrument
69
Advertisement
Table of Contents
