Table of Contents
Advertisement
Overview
You can verify the operation of your TEMPpoint, VOLTpoint, or MEASURpoint instrument
using the base version of the QuickDAQ application that is provided with the instrument.
(Refer to
page 29
This chapter describes how to use QuickDAQ to measure and display temperature and
voltage data from a data acquisition device. For this example, the following sensors are
connected to a DT9874 MEASURpoint instrument:
• T thermocouple is connected to analog input channel 0
• 4-wire, Euro PT1000 RTD is connected to analog input channel 8
• ±10 V input signal is connected to analog input channel 16
for information on installing the QuickDAQ application.)
Verifying the Operation of Your Instrument
65
Advertisement
Table of Contents
